2010年9月13日 星期一

Wii[軟改] 4.2 J系統可以玩新超瑪

轉自ptt的kyo0721
請利用下面方法重新破解主機,並利用USB Loader執行
                                                                                
a. 準備所需檔案
                                                                                
1. 
下載整合包  (上傳到付費的bdg不用擔心會檔案消失,除非我沒繳錢)




一定要用續傳軟體因為檔案很大,很容易出現斷線失敗(點這看續傳教學)
2. 解壓縮至SD卡根目錄
                                                                                
                                                                                
b. 安裝HBC、DVDx、BootMii
                                                                                
1. 點擊左下角SD標示進入SD選單
                                                                                
2. 載入完成後會出視窗詢問是否執行boot.dol/elf,選是執行
注意:
1. 若無視窗跳出,請使用Bannerbomb 4.2資料夾中的壓縮檔解
   壓縮後取代根目錄下的private資料夾
2. 若仍無法正常載入或發生當機現象,請以Smash Stack或
   Indiana Pwns取代Bannerbomb
                                                                                
3. 按1進入安裝畫面
                                                                                
4. 此處檢查是否可正常安裝HBC、DVDX與BootMii,若有紅色表無法正常安裝
                                                                                
5. 選擇Install The Homebrew Channel後,按A繼續
                                                                                
6. 此時詢問是否安裝Homebrew Channel,選擇Yes, continue後,按A繼續
                                                                                
7. 安裝完成,按A繼續
                                                                                
8. 選擇Install DVDX後,按A繼續
註:若不想在Wii上播放DVD影音光碟,此軟體可略過不裝
                                                                                
9. 此時詢問是否安裝DVDX,選擇Yes, continue後,按A繼續
                                                                                
10. 安裝完成,按A繼續
                                                                                
11. 選擇BootMii . . .後,按A繼續
註:若無法安裝為boot2,請選擇Install BootMii as IOS後,按A繼續
                                                                                
11.1. 將BootMii安裝在Boot2的位置
  11.1.1. 選擇Install BootMii as boot2後,按A繼續
                                                                                
  11.1.2. 此時請確定主機中有SD卡後,選擇Yes, continue後,按A繼續
                                                                                
  11.1.3. 安裝所需檔案已寫入SD卡中,選擇Yes, continue後,按A繼續安裝BootMii
                                                                                
  11.1.4. 安裝完成,按A繼續
                                                                                
11.2. 將BootMii安裝成IOS
  11.2.1. 選擇Install BootMii as IOS後,按A繼續
                                                                                
  11.2.2. 此時請確定主機中有SD卡後,選擇Yes, continue後,按A繼續
                                                                                
  11.2.3. 安裝所需檔案已寫入SD卡中,選擇Yes, continue後,按A繼續安裝BootMii
                                                                                
  11.2.4. 安裝完成,按A繼續
                                                                                
12. 安裝完成,選擇Reture to the main menu後,按A返回主選單
                                                                                
13. 所有安裝完成,選擇Exit,按A離開
                                                                                
                                                                                
c. cIOS安裝
1. 透過HBC執行Trucha Bug Restorer
                                                                               
                                                                                
2. 降級IOS15
 2.1. 選擇IOS36後按A執行
                                                                                
 2.2. 此時請稍待,勿點擊任何按鈕
                                                                                
 2.3. 按1繼續
                                                                                
 2.4. 選擇Downgrade IOS15後按A執行
                                                                                
 2.5. 選擇載入IOS15v523的載入位置,此處請選擇Load IOS from sd card,並按A繼續
                                                                                
 2.6. 選擇載入IOS15v257的載入位置,此處請選擇Load IOS from sd card,並按A繼續
                                                                                
 2.7. 準備完成,按A開始第一步驟
                                                                                
 2.8. 第一步驟完成,按A繼續第二步驟
                                                                                
 2.9. IOS15降級完成,按任意鍵退出
                                                                                
3. 修改IOS36
 3.1. 重新進入Trucha Bug Restorer ,選擇IOS15後按A執行
                                                                              
                                                                               
 3.2. 按1繼續
                                                                                
 3.3. 選擇IOS36 menu後按A執行
                                                                                
 3.4. 選擇安裝於36的位置,並且開啟三個選項
                                                                                
 3.5. 按A繼續
                                                                                
 3.6. 選擇載入IOS36v3351的載入位置,此處請選擇Load IOS from sd card,並按A繼續
                                                                                
 3.7. 按A繼續
                                                                                
 3.8. 執行完成,按任意鍵離開。此時IOS36便已具備Trucah Bug,
      可以用來安裝cIOS、wad、preloader。
                                                                                
4. 還原IOS15
 4.1. 重新進入Trucha Bug Restorer,選擇IOS36後按A執行
                                                                                
 4.2. 按1繼續
                                                                                
 4.3. 選擇Restore IOS15後按A執行
                                                                                
 4.4. 選擇載入IOS15v523的載入位置,此處請選擇Load IOS from sd card,並按A繼續
                                                                                
 4.5. 按A開始執行安裝
                                                                                
 4.6. 安裝完成,按任意鍵離開
                                                                                
5. 啟動Wad Manager 1.5,選擇IOS36載入後分別移除IOS222v65280、
   IOS223v65280、IOS249v65280、IOS250v65280
                                                                                
6. 分別安裝IOS222v4、IOS223v4、IOS249rev14、IOS250rev14
                                                                                
7. 安裝完成後按Home鍵離開
                                                                                
至此完成破解。

沒有留言:

張貼留言